Kbc-networks MPEG4 Encoder Manuel d'utilisateur télécharger pdf (Page 10)

Encoder User Manual

Manual-MPEG4_ENCA-Rev1206

 Video Streaming Method

TCP

 Video Resolution

D1, 720 x 480 (NTSC)

 Frame Rate & Mode

30 FPS, Constant

 Video Bit Rate & Mode

1.2 Mbps, Constant

 Serial Port Baud Rate

9600 BPS

 Serial Port Control

8, None, 1

 Video Control Port

6001

 Video Streaming Port

6002

2.3.1.2 Factory Defaults

When the reset button on the face of the unit is pressed, or a reset is performed

form the product interface, the parameters of the encoder will become (differences

from manual settings in italics):

 LAN/WAN IP Address

192.168.0.100

 LAN/WAN Subnet Mask

255.255.255.0

 Gateway IP Address

192.168.0.254

 GUI Access User Account ID

admin

 GUI Access Password

123456

 Audio In

Disabled

 Data Protocol Selection (Dip Switch)

RS-422/485

 Video Compression Type

MPEG-4

 Video Streaming Method

TCP

 Video Resolution

D1, 720 x 480 (NTSC)

 Frame Rate & Mode

30 FPS, Constant

 Video Bit Rate & Mode

1.2 Mbps, Constant

 Serial Port Baud Rate

9600 BPS

 Serial Port Control

8, None, 1

 Video Control Port

6001

 Video Streaming Port

6002

2.3.2 Bench Test Set Up

KBC Networks recommends that all equipment be bench tested before being installed on

site. One crossover Ethernet cable is required.

1. Remove the encoder and/or decoder from box. The encoder IP address is factory

set to 192.168.1.100, the decoder IP address is factory set to 192.168.1.101

unless otherwise noted on provided documentation. The IP addresses do not

need to be changed for the units to operate individually or as a system. If you

will be using multiple encoder and decoder in a system, please see the advanced

operation section of this manual for setup. The encoder and decoder operate as a

pair and the IP addresses have been set accordingly.

2. Mount the encoder at the desired location. The encoder is not weatherproof and

will need to be mounted in a suitable environmental enclosure if used outside or

in a harsh environment. If the encoder is part of the Encoder/Decoder Kit (EDKT-

A-W), the included KBC housing is suitable for outdoor and/or harsh

environments provided the minimum and maximum temperature specifications of

the encooder are not exceeded.

3. Connect the analog video cable from the analog video source to the VIDEO-IN

port. If the system requires data transmission (pan/tilt/zoom or other

RS485/422/232 data) connect the wires from the data device the RS485/422/232

Tx+, Tx-, Rx+ & Rx- ports. If the system requires alarm communication and/or

audio, connect alarm device wires to the Digital Input (DI) ports and

mic/speakers to in/out ports.

4. Connect the LAN/WAN port of the encoder to the wired or wireless network. The

green LED on the front on the encoder will illuminate if the encoder is connected

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Kbc-networks MPEG4 Encoder Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Kbc-networks MPEG4 Encoder